How To Install A Metal Door
The most important door of a house is, without a doubt, that of the entrance. In addition to being the letter of introduction of the inhabitants of that house, it must provide the greatest possible security.
For this reason, this time, we will teach you how to install a metal entrance door in the block, with a wooden finish, which, besides protecting us, will be aesthetically attractive.
Step By Step To Install A Metal Door
Before buying the door, we must properly measure the hole in which we are going to install it. We will measure the height and width at several points and take into consideration the smallest one.
Next, we present the blocked door in the hole to check that it fits in all the points. Otherwise, we solve the problem by opening or closing the gap.
How To Install A Metal Door – Step 1
This type of door is fixed to the wall using metal anchoring pins that are on the sides of the frame. To ensure a strong and durable fastening of the door, it is important that the pins that are on the side of the hinges located at the height of them and those on the other side 20 centimeters from the ends.
How To Install A Metal Door – Step 2
Wepresent the door, well flush, in the hole and mark the areas of support on the wall. It is convenient to draw an area wider than the size of the anchor so that it can be fixed better.
How To Install A Metal Door – Step 3
With the chisel and a pot, we pricked in all the indicated zone until arriving at the solid brick of the wall. To work more safely, we will put on gloves and goggles.
How To Install A Metal Door – Step 4
The next step is to release the bottom plate of the door, with the supports, and present the assembly on the floor. We mark the fixing points and drill holes. To perform this task, we will use the drill and a widia bit of the appropriate diameter.
How To Install A Metal Door – Step 5
Then, we put the plate back on the floor, insert some blocks and fix the supports with their corresponding screws. To insert them, we will have to replace the bit with a tip that adapts to the size and shape of the screw head.
How To Install A Metal Door – Step 6
Once we have screwed the two fasteners, remove the plate and bend the V-anchors.
How To Install A Metal Door – Step 7
We put the door in the hole and adjust it. We will have to leave it perfectly plumb, inserting wedges where necessary. To do this work, we will help ourselves with a spirit level.
How To Install A Metal Door – Step 8
Next, we will secure the fastening of the door in the wall with esparto grass and plaster. For that, pour water in the drawer and add plaster.
How To Install A Metal Door – Step 9
After removing it, we added the esparto grass and began to fill in the holes in the wall. It is important to put the mixture well to the bottom, tucking it between the remains of bricks and hugging the metal pins of the fence.
How To Install A Metal Door – Step 10
Once the product has dried, finish the anchors applying plaster regularly and uniformly. That is, we should leave the surface as much as possible.
How To Install A Metal Door – Step 11
Then, fill the joints between the door and the wall with polyurethane foam. Shake the boat well and placing the container down, we apply the product. We put on some latex gloves.
How To Install A Metal Door – Step 12
Once the drying time indicated by the manufacturer has passed, we remove the excess with a shear.
How To Install A Metal Door – Step 13
Come now with the finish. We go over the surface well with the sander provided with fine grain sandpaper, remove the dust produced, and give a finishing putty.
How To Install A Metal Door – Step 14
We Wait For It To Dry And Paint The Wall.
How To Install A Metal Door – Step 15
Finally, we fix the jambs with mounting adhesive. Following the guidelines that we have given you, you can also place a metal door in a block, without problems. The door entry system in a block makes installation very simple since the frame and the door leaf are pre-installed, and you have to anchor it to the wall structure.
…
